The hardware dongle (HASP key) is needed for full time running of Klinkmann Software. The presence of
HASP key is determined by HASP Device Driver. The HASP Device Driver setup is performed during the Klinkmann Software setup. Without HASP Device Driver installed, Klinkmann Software will
run only 1 hour (with all features enabled).
Usually the HASP Device Driver v4.95 is installed during the Klinkmann Software installation. But, for some older HASP keys (HASP-3) it is possible the HASP Device Driver v4.95 cannot determine
the presence of HASP key. In such cases it is necessary to remove the installed HASP Device Driver v4.95 and install the older v4.02 of HASP Device Driver.
To remove the HASP Device Driver v4.95, in Control Panel "Add/Remove Programs" select
"HASP Device Driver", choose "Automatic" Uninstall Method and perform the uninstallation.
To install the HASP Device Driver v4.02, start HASP Device Driver v4.02 installation package (HDD32402.EXE), select the "Typical" setup type and
perform the installation.
To uninstall the HASP Device Driver v4.02, start HASP Device Driver v4.02 installation package (HDD32402.EXE), select the "Remove" as a setup type and
perform the uninstallation.
